• Before cleaning, be sure to turn off and unplug the unit.
• Keep the fan clean. Carefully wipe the unit with a soft, damp cloth. Please be very cautious near the motor.
• DO NOT immerse the fan in water and never allow water to drip into the Motor Housing.
• Never use gasoline, benzene or thinner. This will damage the surface of the unit.
• After cleaning, be sure to completely dry the unit with a cloth or towel.

• Your fan can be stored in the off-season.
• Before putting the fan in storage, clean it thoroughly, cover it with a vinyl bag, and store it in a cool and dry place. We recommend using the original (or appropriately sized) box.

• Carefully remove your fan from the box (please save the carton for off-season storage).
• Make sure the unit is in the OFF position before plugging the unit into the outlet.
• For shipping purposes, the fan is packed unassembled.

1. Unscrew the setting screw located on the bottom of the motor housing.
2. Insert the end of the plastic pole of the base into the bottom of motor housing and screw firmly by using setting-screw.

1. Plug the power cord into any standard 120V AC, 60HZ outlet. Please make sure the Selector (Speed Control) is in the OFF position. A loose fit between the AC outlet and plug may cause over heating of the plug. Have a qualified electrician to replace the old outlet if the power cord feels extremely hot.
2. 2 Speed Slide Switch: The switch is located on the back of the motor, slide to left for low setting, to the right for high setting.
3. Tilt Adjustment Knob: Loosen tilt adjustment knob (setting-screw) counterclockwise. Adjust desired angle of fan. Firmly tighten the tilt angle adjustment knob.